Product application:
UV cured adhesive that can be cured under UV light with a wavelength of 365-420nm and is able to dry. Typical application for LCD liquid crystal sealing/clamping PIN and metal pin packaging and fixation.

Product features:
Excellent adhesion to LCD glass panels;
Not polluting the LCD and not reacting when in contact with cleaning agents;
Low odor, flexible formula, low shrinkage rate after curing, fast deep curing and surface drying speed;
Moderate viscosity, suitable for glue application;
High strength, does not affect electrical performance, resistant to environmental testing, long boiling time, good resistance to high and low temperatures, and impact performance.

Performance parameters:
Appearance: Transparent liquid
Viscosity: 14000-16000
Hardness: Shore 75D
Curing energy 800mj-1100mj
Tensile strength:>30 (MPa)

Usage:
First, clean and air dry the surface of the adhesive, drop a small amount of adhesive solution onto the adhesive, press the surface tightly, and remove any bubbles in the adhesive layer. Use a high-pressure mercury lamp (power~250 W) to irradiate at a distance of~3cm for~12 seconds, or directly irradiate with sunlight for~25 seconds to cure (the curing time varies depending on the transparent material and lighting fixture). After leaving for 1 hour, the performance of the invisible adhesive reaches its best.


matters needing attention:
This product has a slight irritation to the skin. When using, avoid direct contact with the skin and inhalation of steam to prevent dripping into the eyes. After use, please wash with soapy water