brief introduction

Wesbond 3360 epoxy resin adhesive consists of two parts: the main agent and the hardener. AB and AB agents are mixed according to the required ratio for the job, and can produce strong adhesion between the two adhesives within minutes or hours. It is widely used in coatings, civil engineering, electrical insulation materials, adhesives, and stabilizers. For the fixed and continuous use of metals, glass, ceramics, wood, electronic components, and plastics, it has the characteristics of low-temperature curing, high toughness, oil resistance, drug resistance, good electrical durability, high adhesion, no pollution, and stable performance.

Application scope

• Glass, cement products, plastics, ceramics, metals, stones, electronic components
• Product Model: 3360
• Product appearance: Colorless transparent liquid
• Effective substance: 100%
• Viscosity: 10000~12000 mPa · s
• Mixing ratio A/B: 1:1
• Tensile shear kgf/cm 2:30
• Specific gravity A/B: 1.17/1
• Curing time: Operating time: 8 minutes, fully cured for 24 hours,
• Temperature range: -30~100 ℃

Usage Method

• The ratio of the main agent to the hardener is 10:1. After mixing, stir evenly and apply it to the substrate, then lightly press it with adhesive.
• Appropriate surface treatment: If there is grease or oil on the surface of the bonded body, it must be removed or ground to remove it. Plastic or rubber surfaces also need to be treated appropriately.

• Seal and avoid exposure to sunlight.
• Shelf life of 6 months